自主导航与自动避障虚拟机连接树莓派sshclbrobot@ip#ip指的是树莓派的iproslaunchclbrobotbringup.launch#激活树莓派树莓派端打开导航[email protected]在虚拟机端启动地图rosrunrvizrviz打开导航配置点击openfile打开

ROS用hector创建地图连接小车sshclbrobot@clbrobot激活树莓派roslaunchclbrobotbringup.launch打开hector_slam重新开终端打开hector_slamsshclbrobot@iproslaunchclbrobothector_slam.launch打开地图rosrunrvizrviz点击file，然后点击openconfig。路径：rik

ROS机器人SLAM创建地图连接小车sshclbrobot@clbrobot激活树莓派roslaunchclbrobotbringup.launch开启雷达打开另一个终端输入：sshclbrobot@clbrobot注意：必须已经校正完成继续输入：#打开雷达roslaunchclbrobotlidar_slam.launchc出现“odomreceived!”就代

ROS机器人摄像头寻线连接小车注意：必须在同一区域网sshclbrobort@clbrobort激活树莓派主板roslaunchclbrobotbringup.launch开启摄像头开新终端输入：[email protected]打开寻线控制器roslaucnriki_line_followerriki_line.launch

vROS机器人IMU自动校正连接小车注意：必须在同一区域网sshclbrobort@clbrobort激活树莓派主板roslaunchclbrobotbringup.launch自动校正IMU的过程重新打开一个终端连接小车后打开工程roscdclbrobot/cdparamcdimuvimimu_calib.yaml#查看imurostopicecho

ROS机器人雷达跟随初始化打开一个终端输入：sshclbrobot@ip#连接小车roslaunchclbrobotbringup.launch#激活主板开启摄像头开新终端输入：[email protected]启动雷达sshclbrobot@iproslaunchriki_lidar_followerlaster_follower