HCL华三模拟器BGP配置更新源

peer connect-interface命令用来指定与对等体/对等体组创建BGP会话时建立TCP连接使用的源接口，即采用指定源接口的IP地址/IPv6地址与对等体/对等体组建立TCP连接。

本命令的作用与peer source-address命令的作用类似：peer source-address命令直接指定建立TCP连接的源地址；本命令通过指定源接口，间接指定建立TCP连接的源地址。在一台BGP路由器上如果同时执行本命令和peer source-address命令，则后执行的配置覆盖之前的配置。

#
ospf 1 router-id 2.2.2.2
area 0.0.0.0
network 20.1.1.0 0.0.0.255
network 100.1.1.0 0.0.0.255

interface LoopBack2
ip address 100.1.1.2 255.255.255.0
ip address 100.1.1.3 255.255.255.0 sub
ip address 100.1.1.4 255.255.255.0 sub
ip address 100.1.1.5 255.255.255.0 sub
ip address 100.1.1.6 255.255.255.0 sub


interface GigabitEthernet0/0
port link-mode route
combo enable copper
ip address 20.1.1.1 255.255.255.0
#bgp 100

peer 20.1.2.2 as-number 100

#
address-family ipv4 unicast
peer 20.1.2.2 enable
#

#
ospf 1 router-id 3.3.3.3
 area 0.0.0.0
  network 20.1.1.0 0.0.0.255
  network 20.1.2.0 0.0.0.255
#

interface GigabitEthernet0/0
 port link-mode route
 combo enable copper
 ip address 20.1.1.2 255.255.255.0
#
interface GigabitEthernet0/1
 port link-mode route
 combo enable copper
 ip address 20.1.2.1 255.255.255.0
#

ospf 1 router-id 4.4.4.4
 area 0.0.0.0
  network 20.1.2.0 0.0.0.255
#

interface GigabitEthernet0/0
 port link-mode route
 combo enable copper
 ip address 20.1.2.2 255.255.255.0
#

bgp 100
 peer 100.1.1.2 as-number 100
 #
 address-family ipv4 unicast
  peer 100.1.1.2 enable
#

不用配置更新源，即可连接