华为华三锐捷交换机配置端口聚合

标签：H3C Ruijie 端口 GigabitEthernet1 交换机 interface 华三锐 config port

 华为-配置手工/LACP模式链路聚合

 1、配置手工模式链路聚合（默认模式）  

[HUAWEI] interface eth-trunk 1 

[HUAWEI-Eth-Trunk1] trunkport gigabitethernet 1/0/1 to 1/0/3 

[HUAWEI-Eth-Trunk1] port link-type trunk 

[HUAWEI-Eth-Trunk1] port trunk allow-pass vlan 10 20 

[HUAWEI-Eth-Trunk1] quit 

2、配置LACP模式的链路聚合 

[HUAWEI] interface eth-trunk 1 

[HUAWEI-Eth-Trunk1] mode lacp 

[HUAWEI-Eth-Trunk1] trunkport gigabitethernet 1/0/1 to 1/0/3 

[HUAWEI-Eth-Trunk1] port link-type trunk 

[HUAWEI-Eth-Trunk1] port trunk allow-pass vlan 10 20 

[HUAWEI-Eth-Trunk1] quit 

 华三-二层静态聚合配置举例 

 1、# 创建二层聚合接口1  

[H3C] interface bridge-aggregation 1 

[H3C-Bridge-Aggregation1] quit 

2、# 分别将端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入到聚合组1中。 

[H3C] interface gigabitethernet 1/0/1 

[H3C-GigabitEthernet1/0/1] port link-aggregation group 1 

[H3C-GigabitEthernet1/0/1] quit 

[H3C] interface gigabitethernet 1/0/2 

[H3C-GigabitEthernet1/0/2] port link-aggregation group 1 

[H3C-GigabitEthernet1/0/2] quit 

[H3C] interface gigabitethernet 1/0/3 

[H3C-GigabitEthernet1/0/3] port link-aggregation group 1 

[H3C-GigabitEthernet1/0/3] quit 

3、# 配置二层聚合接口1为Trunk端口，并允许VLAN 10和20的报文通过。 

[H3C] interface bridge-aggregation 1 

[H3C-Bridge-Aggregation1] port link-type trunk 

[H3C-Bridge-Aggregation1] port trunk permit vlan 10 20 

[H3C-Bridge-Aggregation1] quit 

 华三-二层动态聚合配置举例  

1、# 创建二层聚合接口1，并配置该接口为动态聚合模式 

[H3C] interface bridge-aggregation 1 

[H3C-Bridge-Aggregation1] link-aggregation mode dynamic 

[H3C-Bridge-Aggregation1] quit 

2、# 分别将端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入到聚合组1中。 

[H3C] interface gigabitethernet 1/0/1 

[H3C-GigabitEthernet1/0/1] port link-aggregation group 1 

[H3C-GigabitEthernet1/0/1] quit 

[H3C] interface gigabitethernet 1/0/2 

[H3C-GigabitEthernet1/0/2] port link-aggregation group 1  

[H3C-GigabitEthernet1/0/2] quit 

[H3C] interface gigabitethernet 1/0/3 

[H3C-GigabitEthernet1/0/3] port link-aggregation group 1 

[H3C-GigabitEthernet1/0/3] quit 

3、# 配置二层聚合接口1为Trunk端口，并允许VLAN 10和20的报文通过。 

[H3C] interface bridge-aggregation 1 

[H3C-Bridge-Aggregation1] port link-type trunk 

[H3C-Bridge-Aggregation1] port trunk permit vlan 10 20 

[H3C-Bridge-Aggregation1] quit 

 锐捷-配置静态/动态模式链路聚合 

1、二层静态链路聚合 

Ruijie(config)#interface range gigabitEthernet 0/1-3 

Ruijie(config-if-range)#port-group 1 

Ruijie(config-if-range)#exit 

Ruijie(config)#interface aggregateport 1 

Ruijie(config-if-AggregatePort 1)#switchport mode trunk 

Ruijie(config-if-AggregatePort 1)#exit 

Ruijie(config)#aggregateport load-balance src-dst-ip 

Ruijie(config)#exit 

2、二层动态链路聚合 

Ruijie(config)#interface range gigabitEthernet 0/1-3 

Ruijie(config-if-range)#port-group 1 mode active 

Ruijie(config-if-range)#exit 

Ruijie(config)#interface aggregateport 1 

Ruijie(config-if-AggregatePort 1)#switchport mode trunk 

Ruijie(config-if-AggregatePort 1)#exit 

Ruijie(config)#aggregateport load-balance src-dst-ip 

Ruijie(config)#exit 

   

标签：H3C,Ruijie,端口,GigabitEthernet1,交换机,interface,华三锐,config,port
From： https://www.cnblogs.com/speednet/p/16919100.html